[Maksik]

Нашел тут процесс обучения на сайте мек-а, в письме Mitsu motors. Нам бы переводчика толкового))))

11. Start engine, check any fuel leakage and if the engine idling speed is not stable due to reset of the learning value, perform the following processes.

a. Warm up engine until the coolant temperature becomes more than 85 degrees Celsius.
b. Turn the IG key in the “Lock (OFF)” position.
c. Wait 10 seconds then start engine again and keep idling for 10 minutes in the conditions of A/Tshift in the P-position, the blower fan is off and the engine coolant temperature is more than 83 degrees Celsius.
d. Once stop engine and restart it and keep idling for 10 minutes in the conditions of A/T shift in the P-position, the blower fan is on in the high position, A/C is on at max cool position, all the windows are open and the engine coolant temperature is more than 83 degrees Celsius.
e. Repeat the process “d” again.

[Notes]
- If the ambient temperature is more than 20 degrees Celsius and the A/C compressor is
working all the time during the process “d”, the process “e” can be skipped.
- If the engine stalls at the changing timing between the lean mode to the stoichiometric
mode, clean up the throttle valve area and perform the above full processes.